Source:Bb:Wlad#

SCPI Commands

[SOURce<HW>]:BB:WLAD:DPMode
[SOURce<HW>]:BB:WLAD:FTYPe
[SOURce<HW>]:BB:WLAD:ITIMe
[SOURce<HW>]:BB:WLAD:PRESet
[SOURce<HW>]:BB:WLAD:SLENgth
[SOURce<HW>]:BB:WLAD:STATe

Cloning the Group

// Create a clone of the original group, that exists independently
var wlad2 = driver.Source.Bb.Wlad.Clone();

Direct SCPI Members

WlanadDmgPhyModeEnum DpMode#
// SCPI: [SOURce<HW>]:BB:WLAD:DPMode
WlanadDmgPhyModeEnum value = driver.Source.Bb.Wlad.DpMode;
driver.Source.Bb.Wlad.DpMode = WlanadDmgPhyModeEnum.CONTrol;

Sets the DMG/EDMG PHY mode.

dpMode: CONTrol | SINGle | ESINgle

  • CONTrol: DMG control PHY mode

  • SINGle: DMG SC PHY mode

  • ESINgle: EDMG SC PHY mode


WlanadFrameTypeEnum Ftype#
// SCPI: [SOURce<HW>]:BB:WLAD:FTYPe
WlanadFrameTypeEnum value = driver.Source.Bb.Wlad.Ftype;
driver.Source.Bb.Wlad.Ftype = WlanadFrameTypeEnum.BEACon;

Queries the IEEE 802.11ad/ay frame type. All frames are data frames.

ftype: DATA


double Itime#
// SCPI: [SOURce<HW>]:BB:WLAD:ITIMe
double value = driver.Source.Bb.Wlad.Itime;
driver.Source.Bb.Wlad.Itime = 1.0;

Sets the idle time, the time delay between the frames.

itime: float


void Preset ( )#
void PresetAndWait ( )#
void PresetAndWait ( int opcTimeoutMs )
// SCPI: [SOURce<HW>]:BB:WLAD:PRESet
driver.Source.Bb.Wlad.Preset();
driver.Source.Bb.Wlad.PresetAndWait();
driver.Source.Bb.Wlad.PresetAndWait(1000);

Sets the parameters of the digital standard to their default values (*RST values specified for the commands) . Not affected is the state set with the command BB:WLAD:STATe.

PresetAndWait is the same as Preset, but waits for the operation to complete. The optional entered opcTimeoutMs is only valid for this call. If you omit the opcTimeoutMs, the method uses the settable value RsSmw.Utilities.OpcTimeout.


int Slength#
// SCPI: [SOURce<HW>]:BB:WLAD:SLENgth
int value = driver.Source.Bb.Wlad.Slength;
driver.Source.Bb.Wlad.Slength = 1;

Sets the sequence length.

slength: integer


bool State#
// SCPI: [SOURce<HW>]:BB:WLAD:STATe
bool value = driver.Source.Bb.Wlad.State;
driver.Source.Bb.Wlad.State = false;

Activates the standard and deactivates all the other digital standards and digital modulation modes in the same path.

state: 1 | ON | 0| OFF


Subgroups