Source:Bb:W3Gpp:Ts25141:Tcase:Execute#

SCPI Commands

[SOURce]:BB:W3GPp:TS25141:TCASe:EXECute

Direct SCPI Members

void Set ( )#
void SetAndWait ( )#
void SetAndWait ( int opcTimeoutMs )
// SCPI: [SOURce]:BB:W3GPp:TS25141:TCASe:EXECute
driver.Source.Bb.W3Gpp.Ts25141.Tcase.Execute.Set();
driver.Source.Bb.W3Gpp.Ts25141.Tcase.Execute.SetAndWait();
driver.Source.Bb.W3Gpp.Ts25141.Tcase.Execute.SetAndWait(1000);

The command activates the current settings of the test case wizard. Signal generation is started at the first trigger received by the generator. The RF output is not activated /deactivated by this command, so care has to be taken that RF State is On (OUTPut:STATe ON) at the beginning of the measurement. The command activates the preset parameters of the TS25141 commands and - for most test cases - also the parameters of one or more of the subsystems SOURce:AWGN, SOURce:W3GPp, SOURce:DM and SOURce:FSIM.

SetAndWait is the same as Set, but waits for the operation to complete. The optional entered opcTimeoutMs is only valid for this call. If you omit the opcTimeoutMs, the method uses the settable value RsSmw.Utilities.OpcTimeout.