Source:Bb:Pramp#

SCPI Commands

[SOURce<HW>]:BB:PRAMp:PRESet
[SOURce<HW>]:BB:PRAMp:STATe

Cloning the Group

// Create a clone of the original group, that exists independently
var pramp2 = driver.Source.Bb.Pramp.Clone();

Direct SCPI Members

void Preset ( )#
void PresetAndWait ( )#
void PresetAndWait ( int opcTimeoutMs )
// SCPI: [SOURce<HW>]:BB:PRAMp:PRESet
driver.Source.Bb.Pramp.Preset();
driver.Source.Bb.Pramp.PresetAndWait();
driver.Source.Bb.Pramp.PresetAndWait(1000);

Sets the parameters of the power sweep to their default values (*RST values specified for the commands) . Not affected is the state set with the command method RsSmw.Source.Bb.Pramp.State.

PresetAndWait is the same as Preset, but waits for the operation to complete. The optional entered opcTimeoutMs is only valid for this call. If you omit the opcTimeoutMs, the method uses the settable value RsSmw.Utilities.OpcTimeout.


bool State#
// SCPI: [SOURce<HW>]:BB:PRAMp:STATe
bool value = driver.Source.Bb.Pramp.State;
driver.Source.Bb.Pramp.State = false;

Activates power sweep signal generation, and deactivates all digital standards, digital modulation modes and other sweeps in the corresponding path.

state: 1 | ON | 0| OFF


Subgroups