Sequencer

SCPI Command :

INITiate:SEQuencer:ABORt

Commands in total: 4

Subgroups: 3

Direct child commands: 1

abort() → None

# INITiate:SEQuencer:ABORt
driver.initiate.sequencer.abort()

Stops the currently active sequence of measurements. You can start a new sequence any time using method RsFsw.initiate.sequencer.immediate.perform() .

abort_with_opc(opc_timeout_ms: int = -1) → None

# INITiate:SEQuencer:ABORt
driver.initiate.sequencer.abort_with_opc()

Stops the currently active sequence of measurements. You can start a new sequence any time using method RsFsw.initiate.sequencer.immediate.perform() .

Same as abort, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.

Cloning the Group

# Create a copy of the original group, that exists independently
sequencer_copy = driver.initiate.sequencer.clone()

Subgroups

• Immediate
• Mode
• Refresh
  • All