Exclusive

SCPI Command :

CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>[:EXCLusive]

class ExclusiveCls[source]

Exclusive commands group definition. 1 total commands, 0 Subgroups, 1 group commands

get(window=Window.Default, limitIx=LimitIx.Default, subBlock=SubBlock.Default, powerClass=PowerClass.Default) → bool[source]

# SCPI: CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>[:EXCLusive]
value: bool = driver.calculate.limit.espectrum.pclass.exclusive.get(window = repcap.Window.Default, limitIx = repcap.LimitIx.Default, subBlock = repcap.SubBlock.Default, powerClass = repcap.PowerClass.Default)

Selects the power class used by the measurement if method RsFsw.Calculate.Limit.Espectrum.Mode.set is set to manual. Note that:

INTRO_CMD_HELP: Note that this command replaces the two commands from previous signal and spectrum analyzers (which are still supported, however) :

You can only use power classes for which limits are defined.

param window

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

param limitIx

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Limit’)

param subBlock

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Espectrum’)

param powerClass

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Pclass’)

return

state: ON | OFF | 1 | 0

set(state: bool, window=Window.Default, limitIx=LimitIx.Default, subBlock=SubBlock.Default, powerClass=PowerClass.Default) → None[source]

# SCPI: CALCulate<n>:LIMit<li>:ESPectrum<sb>:PCLass<pc>[:EXCLusive]
driver.calculate.limit.espectrum.pclass.exclusive.set(state = False, window = repcap.Window.Default, limitIx = repcap.LimitIx.Default, subBlock = repcap.SubBlock.Default, powerClass = repcap.PowerClass.Default)

Selects the power class used by the measurement if method RsFsw.Calculate.Limit.Espectrum.Mode.set is set to manual. Note that:

INTRO_CMD_HELP: Note that this command replaces the two commands from previous signal and spectrum analyzers (which are still supported, however) :

You can only use power classes for which limits are defined.

param state

ON | OFF | 1 | 0

param window

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

param limitIx

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Limit’)

param subBlock

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Espectrum’)

param powerClass

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Pclass’)