Fline<FreqLine>

RepCap Settings

# Range: Nr1 .. Nr4
rc = driver.calculate.fline.repcap_freqLine_get()
driver.calculate.fline.repcap_freqLine_set(repcap.FreqLine.Nr1)

SCPI Command :

CALCulate<n>:FLINe<dl>

class FlineCls[source]

Fline commands group definition. 2 total commands, 1 Subgroups, 1 group commands Repeated Capability: FreqLine, default value after init: FreqLine.Nr1

get(window=Window.Default, freqLine=FreqLine.Default) → float[source]

# SCPI: CALCulate<n>:FLINe<dl>
value: float = driver.calculate.fline.get(window = repcap.Window.Default, freqLine = repcap.FreqLine.Default)

Defines the position of a frequency line.

param window

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

param freqLine

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Fline’)

return

frequency: Note that you can not set a frequency line to a position that is outside the current span. Range: 0 Hz to Fmax, Unit: HZ

set(frequency: float, window=Window.Default, freqLine=FreqLine.Default) → None[source]

# SCPI: CALCulate<n>:FLINe<dl>
driver.calculate.fline.set(frequency = 1.0, window = repcap.Window.Default, freqLine = repcap.FreqLine.Default)

Defines the position of a frequency line.

param frequency

Note that you can not set a frequency line to a position that is outside the current span. Range: 0 Hz to Fmax, Unit: HZ

param window

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

param freqLine

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Fline’)

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.calculate.fline.clone()

Subgroups

State