Stop#

SCPI Command :

CONFigure:PSWeep:Y:STOP
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get ( ) → float
set ( stop: float ) → None
# CONFigure:PSWeep:Y:STOP
# get:
value: float = driver.applications.k18AmplifierEt.configure.psweep.y.stop.get()
# set:
driver.applications.k18AmplifierEt.configure.psweep.y.stop.set(stop = 1.0)

This command defines the stop value for the second parameter controlled by the parameter sweep.

Parameters:

stop – numeric value whose unit depends on the parameter type you have selected with method RsFsw.applications.k18AmplifierEt.configure.psweep.y.setting.set() : • Hz in case of the center frequency • dBm in case of the output level • s in case of the delay between envelope and RF signal • V in case of the envelope bias