Source:Frequency:Loscillator#

SCPI Commands

[SOURce<HW>]:FREQuency:LOSCillator:MODE

Cloning the Group

// Create a clone of the original group, that exists independently
var loscillator2 = driver.Source.Frequency.Loscillator.Clone();

Direct SCPI Members

LoModeWenum Mode#
// SCPI: [SOURce<HW>]:FREQuency:LOSCillator:MODE
LoModeWenum value = driver.Source.Frequency.Loscillator.Mode;
driver.Source.Frequency.Loscillator.Mode = LoModeWenum.AOFF;

Selects the mode of the local oscillator coupling. <Mode> / Parameter in manual operation / Description

  • INTernal / A&B Internal / Internal (one path instrument) / Uses the internal oscillator signal in both paths.

  • EXTernal / A External & B Internal (one path instrument) / Uses an external signal in path A. B uses its internal signal.

  • COUPled / A Internal & A->B Coupled / Assigns the internal oscillator signal of path A also to path B.

  • ECOupled / A External & A->B Coupled / Assigns an externally supplied signal to both paths.

  • BOFF / A Internal & B RF Off / Uses the internal local oscillator signal of path A, if the selected frequency exceeds the maximum frequency of path B.

  • EBOFf / A External & B RF Off / Uses the LO IN signal for path A, if the selected RF frequency exceeds the maximum frequency of path B.

  • AOFF / A RF Off & B External / Uses the LO IN signal for path B, if the selected RF frequency exceeds the maximum frequency of path A.

mode: See Table “Cross-reference between Mode and the manual operation”


Subgroups