Source:Bb:Wlnn:Trigger:Output:Mode#

SCPI Commands

[SOURce<HW>]:BB:WLNN:TRIGger:OUTPut<CH>:MODE

Direct SCPI Members

WlannMarkModeEnum Get ( )#
WlannMarkModeEnum Get ( OutputRepCap output )
void Set ( WlannMarkModeEnum mode )#
void Set ( WlannMarkModeEnum mode, OutputRepCap output )
// SCPI: [SOURce<HW>]:BB:WLNN:TRIGger:OUTPut<CH>:MODE
// Get:
WlannMarkModeEnum value = driver.Source.Bb.Wlnn.Trigger.Output.Mode.Get();
WlannMarkModeEnum value = driver.Source.Bb.Wlnn.Trigger.Output.Mode.Get(OutputRepCap.Default);
// Set:
driver.Source.Bb.Wlnn.Trigger.Output.Mode.Set(WlannMarkModeEnum.FAPart, OutputRepCap.Default);
driver.Source.Bb.Wlnn.Trigger.Output.Mode.Set(WlannMarkModeEnum.FAPart);

Defines the signal for the selected marker output.

mode RESTart | FRAMe | FAPart | FIPart | PULSe | PATTern | RATio

  • RESTart: A marker signal is generated at the start of each signal sequence (period = all frame blocks) .

  • FRAMe: A marker signal is generated at the start of each frame in the single frame block. Otherwise, the frame block and frame index are entered and the specific frame is masked.

  • FAPart | FIPart: A marker signal is generated to mark every active part of each frame.The active data transfer part (PPDU) of a frame period is marked with high, the inactive part (idle time) with low. This marker can be used to decrease the carrier leakage during inactive signal parts by feeding it into the pulse modulator.Otherwise, the frame block and frame index are entered and the active part of the specific frame is masked.

  • PULSe: A pulsed marker signal is generated. The pulse frequency(= symbol rate/divider) is defined with the :SOUR1:BB:WLNN:TRIG:OUTP:PULS:DIV command and can be queried with the :SOUR1:BB:WLNN:TRIG:OUTP:PULS:FREQ? command.

  • PATTern: A marker signal is generated according to the user-defined pattern (command SOURce:BB:WLNN:TRIGger:OUTPut:PATTern) .

  • RATio: A marker signal corresponding to the Time Off / Time On specifications in the commands :SOUR1:BB:WLNN:TRIG:OUTP:OFFT and :SOUR1:BB:WLNN:TRIG:OUTP:ONT is generated.

output Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.