Source:Bb:Lora#
SCPI Commands
- [SOURce<HW>]:BB:LORA:BWIDth
- [SOURce<HW>]:BB:LORA:IINTerval
- [SOURce<HW>]:BB:LORA:OSAMpling
- [SOURce<HW>]:BB:LORA:PRESet
- [SOURce<HW>]:BB:LORA:SLENgth
- [SOURce<HW>]:BB:LORA:STATe
Cloning the Group
// Create a clone of the original group, that exists independently
var lora2 = driver.Source.Bb.Lora.Clone();
Direct SCPI Members
- LoRaBwEnum Bandwidth#
// SCPI: [SOURce<HW>]:BB:LORA:BWIDth LoRaBwEnum value = driver.Source.Bb.Lora.Bandwidth; driver.Source.Bb.Lora.Bandwidth = LoRaBwEnum.BW10;Sets the channel bandwidth.
bw: BW7 | BW10 | BW15 | BW20 | BW31 | BW41 | BW62 | BW125 | BW250 | BW500
- double Iinterval#
// SCPI: [SOURce<HW>]:BB:LORA:IINTerval double value = driver.Source.Bb.Lora.Iinterval; driver.Source.Bb.Lora.Iinterval = 1.0;Sets the time of the interval separating two frames.
iinterval: float
- int Osampling#
// SCPI: [SOURce<HW>]:BB:LORA:OSAMpling int value = driver.Source.Bb.Lora.Osampling; driver.Source.Bb.Lora.Osampling = 1;Sets the oversampling factor of the generated waveform. A reduced sample rate saves significantly the amount of memory or allows an increased signal cycle time, and vice versa.
osampling: integer
- void Preset ( )#
- void PresetAndWait ( )#
- void PresetAndWait ( int opcTimeoutMs )
// SCPI: [SOURce<HW>]:BB:LORA:PRESet driver.Source.Bb.Lora.Preset(); driver.Source.Bb.Lora.PresetAndWait(); driver.Source.Bb.Lora.PresetAndWait(1000);Sets the parameters of the digital standard to their default values (*RST values specified for the commands) . Not affected is the state set with the command SOURce<hw>:BB:LORA:STATe.
PresetAndWait is the same as Preset, but waits for the operation to complete. The optional entered opcTimeoutMs is only valid for this call. If you omit the opcTimeoutMs, the method uses the settable value
RsSmw.Utilities.OpcTimeout.
- int Slength#
// SCPI: [SOURce<HW>]:BB:LORA:SLENgth int value = driver.Source.Bb.Lora.Slength; driver.Source.Bb.Lora.Slength = 1;Sets the sequence length of the signal in number of frames. The signal is calculated in advance and output in the arbitrary waveform generator.
slength: integer
- bool State#
// SCPI: [SOURce<HW>]:BB:LORA:STATe bool value = driver.Source.Bb.Lora.State; driver.Source.Bb.Lora.State = false;Activates the standard and deactivates all the other digital standards and digital modulation modes in the same path.
state: 1 | ON | 0| OFF
Subgroups