Source:Bb:Evdo:Terminal:Dchannel:Packet:Count#
SCPI Commands
- [SOURce<HW>]:BB:EVDO:TERMinal<ST>:DCHannel:PACKet<CH>:COUNt
Direct SCPI Members
- int Get ( )#
- int Get ( TerminalRepCap terminal, PacketRepCap packet )
- void Set ( int count )#
- void Set ( int count, TerminalRepCap terminal, PacketRepCap packet )
// SCPI: [SOURce<HW>]:BB:EVDO:TERMinal<ST>:DCHannel:PACKet<CH>:COUNt // Get: int value = driver.Source.Bb.Evdo.Terminal.Dchannel.Packet.Count.Get(); int value = driver.Source.Bb.Evdo.Terminal.Dchannel.Packet.Count.Get(TerminalRepCap.Default, PacketRepCap.Default); // Set: driver.Source.Bb.Evdo.Terminal.Dchannel.Packet.Count.Set(1, TerminalRepCap.Default, PacketRepCap.Default); driver.Source.Bb.Evdo.Terminal.Dchannel.Packet.Count.Set(1);
(enabled for an access terminal working in traffic mode) Sets the number of packets to be sent. The number of packets to be send depends on whether the parameter Infinite Packets is enabled or disabled. If Infinite Packetsis enabled, there is no limit to the number of packets sent. If Infinite Packets is disabled, the number of packets can be specified. In this case, the data channel will be switched off after the specified number of packets have been sent. Note: Configuration of Packet 2 and Packet 3 transmitted on the second and the third subframe, is only enabled for physical layer subtype 2.
countintegerterminalRepeated capability selectorpacketRepeated capability selectorWhen you do not use any explicit repeated capability selector, the value is taken from its parent group.