Lower

SCPI Command :

[SENSe]:ADJust:CONFigure:HYSTeresis:LOWer

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get() → float

# [SENSe]:ADJust:CONFigure:HYSTeresis:LOWer
value: float = driver.sense.adjust.configure.hysteresis.lower.get()

When the reference level is adjusted automatically using the method RsFsw.sense.adjust.level.set() command, the internal attenuators and the preamplifier are also adjusted. To avoid frequent adaptation due to small changes in the input signal, you can define a hysteresis. This setting defines a lower threshold the signal must fall below (compared to the last measurement) before the reference level is adapted automatically. This setting can only be adjusted in the MSRA primary application, not in the secondary applications.

Returns:

threshold: Range: 0 dB to 200 dB, Unit: dB

set(threshold: float) → None

# [SENSe]:ADJust:CONFigure:HYSTeresis:LOWer
driver.sense.adjust.configure.hysteresis.lower.set(threshold = 1.0)

When the reference level is adjusted automatically using the method RsFsw.sense.adjust.level.set() command, the internal attenuators and the preamplifier are also adjusted. To avoid frequent adaptation due to small changes in the input signal, you can define a hysteresis. This setting defines a lower threshold the signal must fall below (compared to the last measurement) before the reference level is adapted automatically. This setting can only be adjusted in the MSRA primary application, not in the secondary applications.

Parameters:

threshold – Range: 0 dB to 200 dB, Unit: dB