Write#

SCPI Command :

CONFigure:REFSignal:GOS:WRITe
Commands in total: 1
Subgroups: 0
Direct child commands: 1
set ( ) → None
set_with_opc ( opc_timeout_ms: int = -1 ) → None
# CONFigure:REFSignal:GOS:WRITe
# set:
driver.applications.k18AmplifierEt.configure.refSignal.gos.write.set()
# set_with_opc:
driver.applications.k18AmplifierEt.configure.refSignal.gos.write.set_with_opc(opc_timeout_ms = 3000)

This command internally generates the reference signal based on the signal characteristics that you have defined. The waveform file that has been created is loaded into the DSP of the R&S FSW-K18 and is additionally transferred into the ARB of the signal generator. Make sure to synchronize with *OPC? or *WAI to make sure that the command was successfully applied on the generator before sending the next command.

set_with_opc() does the same as set(), but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.