Write

SCPI Command :

CONFigure:REFSignal:CWF:WRITe

Commands in total: 1

Subgroups: 0

Direct child commands: 1

set() → None

# CONFigure:REFSignal:CWF:WRITe
driver.applications.k18AmplifierEt.configure.refSignal.cwf.write.set()

This command loads a reference signal based on a waveform file into the application. When you turn on the reference signal export to the generator (method RsFsw.applications.k18AmplifierEt.configure.refSignal.cwf.etGenerator.state.set() ) , the command also transfers the waveform file to the generator. Make sure to synchronize with *OPC? or *WAI to make sure that the command was successfully applied on the generator before sending the next command.

set_with_opc(opc_timeout_ms: int = -1) → None

# CONFigure:REFSignal:CWF:WRITe
driver.applications.k18AmplifierEt.configure.refSignal.cwf.write.set_with_opc()

This command loads a reference signal based on a waveform file into the application. When you turn on the reference signal export to the generator (method RsFsw.applications.k18AmplifierEt.configure.refSignal.cwf.etGenerator.state.set() ) , the command also transfers the waveform file to the generator. Make sure to synchronize with *OPC? or *WAI to make sure that the command was successfully applied on the generator before sending the next command.

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.