Stop

SCPI Command :

CONFigure:PSWeep:X:STOP

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get() → float

# CONFigure:PSWeep:X:STOP
value: float = driver.applications.k18AmplifierEt.configure.psweep.x.stop.get()

This command defines the stop value for the first parameter controlled by the parameter sweep.

Returns:

stop: numeric value whose unit depends on the parameter type you have selected with method RsFsw.applications.k18AmplifierEt.configure.psweep.y.setting.set() : - Hz in case of the center frequency - dBm in case of the output level - s in case of the delay between envelope and RF signal - V in case of the envelope bias

set(stop: float) → None

# CONFigure:PSWeep:X:STOP
driver.applications.k18AmplifierEt.configure.psweep.x.stop.set(stop = 1.0)

This command defines the stop value for the first parameter controlled by the parameter sweep.

Parameters:

stop – numeric value whose unit depends on the parameter type you have selected with method RsFsw.applications.k18AmplifierEt.configure.psweep.y.setting.set() : - Hz in case of the center frequency - dBm in case of the output level - s in case of the delay between envelope and RF signal - V in case of the envelope bias