Mode<MimoAntenna>

SCPI Command :

TRIGger[:SEQuence]:MODE<ant>
Commands in total: 1
Subgroups: 0
Direct child commands: 1

Repeated Capability Setting:

# Range: Nr1 .. Nr4

driver.applications.k10Xlte.trigger.sequence.mode.repcap_mimoAntenna_set(repcap.MimoAntenna.Nr1)
get(mimoAntenna=MimoAntenna.Default) → TriggerSourceLte[source]
# TRIGger[:SEQuence]:MODE<ant>
value: enums.TriggerSourceLte = driver.applications.k10Xlte.trigger.sequence.mode.get(mimoAntenna = repcap.MimoAntenna.Default)

Turns continuous triggering on and off.

Parameters:

mimoAntenna – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Mode’)

set(source: TriggerSourceLte, mimoAntenna=MimoAntenna.Default) → None[source]
# TRIGger[:SEQuence]:MODE<ant>
driver.applications.k10Xlte.trigger.sequence.mode.set(source = enums.TriggerSourceLte.BBPower, mimoAntenna = repcap.MimoAntenna.Default)

Turns continuous triggering on and off.

Parameters:

  • source – CONTinuous Continuous measurement STOP Measurement stops after the trigger event is done MARK A free-run measurement is performed; the trigger event is merely indicated in the results, but does not change the behavior of the measurement. This setting is only available for FSW-B512R/-B800R.

  • mimoAntenna – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Mode’)

Cloning the Group

# Create a copy of the original group, that exists independently
mode_copy = driver.applications.k10Xlte.trigger.sequence.mode.clone()