Cw

SCPI Commands :

[SOURce]:BB:W3GPp:TS25141:IFSignal:CW:FOFFset
[SOURce]:BB:W3GPp:TS25141:IFSignal:CW:POWer
[SOURce]:BB:W3GPp:TS25141:IFSignal:CW:STATe

Commands in total: 3

Subgroups: 0

Direct child commands: 3

get_foffset() → float

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:FOFFset
value: float = driver.source.bb.w3Gpp.ts25141.ifRignal.cw.get_foffset()

Sets frequency offset of the CW interfering signal versus the wanted signal RF frequency.

Returns:

foffset: float

get_power() → float

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:POWer
value: float = driver.source.bb.w3Gpp.ts25141.ifRignal.cw.get_power()

Sets the RF level of the CW interfering signal.

Returns:

power: float

get_state() → bool

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:STATe
value: bool = driver.source.bb.w3Gpp.ts25141.ifRignal.cw.get_state()

This command enable/disables the CW interfering signal. In mode ‘According to Standard’ (SOURce:BB:W3GPp:TS25141:EMODe STANdard) , the value is fixed to ON. Sets commands SOURce2:AWGN:CNRatio and SOURce2:AWGN:POWer:NOISe after execution of SOURce:BB:W3GP:TS25141:TCAS:EXEC

Returns:

state: 1 | ON | 0| OFF

set_foffset(foffset: float) → None

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:FOFFset
driver.source.bb.w3Gpp.ts25141.ifRignal.cw.set_foffset(foffset = 1.0)

Sets frequency offset of the CW interfering signal versus the wanted signal RF frequency.

Parameters:

foffset – float

set_power(power: float) → None

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:POWer
driver.source.bb.w3Gpp.ts25141.ifRignal.cw.set_power(power = 1.0)

Sets the RF level of the CW interfering signal.

Parameters:

power – float

set_state(state: bool) → None

# [SOURce]:BB:W3GPp:TS25141:IFSignal:CW:STATe
driver.source.bb.w3Gpp.ts25141.ifRignal.cw.set_state(state = False)

This command enable/disables the CW interfering signal. In mode ‘According to Standard’ (SOURce:BB:W3GPp:TS25141:EMODe STANdard) , the value is fixed to ON. Sets commands SOURce2:AWGN:CNRatio and SOURce2:AWGN:POWer:NOISe after execution of SOURce:BB:W3GP:TS25141:TCAS:EXEC

Parameters:

state – 1 | ON | 0| OFF