System:Communicate:Gpib#

SCPI Commands

SYSTem:COMMunicate:GPIB:LTERminator
SYSTem:COMMunicate:GPIB:RESource

Cloning the Group

// Create a clone of the original group, that exists independently
var gpib2 = driver.System.Communicate.Gpib.Clone();

Direct SCPI Members

IecTermModeEnum Lterminator#
// SCPI: SYSTem:COMMunicate:GPIB:LTERminator
IecTermModeEnum value = driver.System.Communicate.Gpib.Lterminator;
driver.System.Communicate.Gpib.Lterminator = IecTermModeEnum.EOI;

Sets the terminator recognition for remote control via GPIB interface.

lterminator: STANdard | EOI

  • EOI: Recognizes an LF (Line Feed) as the terminator only when it is sent with the line message EOI (End of Line) . This setting is recommended particularly for binary block transmissions, as binary blocks may coincidentally contain a characater with value LF (Line Feed) , although it is not determined as a terminator.

  • STANdard: Recognizes an LF (Line Feed) as the terminator regardless of whether it is sent with or without EOI.


string Resource#
// SCPI: SYSTem:COMMunicate:GPIB:RESource
string value = driver.System.Communicate.Gpib.Resource;

Queries the visa resource string for remote control via the GPIB interface. To change the GPIB address, use the command method RsSmw.System.Communicate.Gpib.Self.Address.

resource: string


Subgroups