Source:Power:Step#

SCPI Commands

[SOURce<HW>]:POWer:STEP:MODE
[SOURce<HW>]:POWer:STEP:[INCRement]

Direct SCPI Members

FreqStepModeEnum Mode#
// SCPI: [SOURce<HW>]:POWer:STEP:MODE
FreqStepModeEnum value = driver.Source.Power.Step.Mode;
driver.Source.Power.Step.Mode = FreqStepModeEnum.DECimal;

Defines the type of step width to vary the RF output power step-by-step with the commands POW UP or POW DOWN. You can define the step mode for each path separately.

mode: DECimal | USER

  • DECimal: Increases or decreases the level in steps of ten.

  • USER: Increases or decreases the level in increments, determined with the command [:SOURcehw]:POWer:STEP[:INCRement].


double Increment#
// SCPI: [SOURce<HW>]:POWer:STEP:[INCRement]
double value = driver.Source.Power.Step.Increment;
driver.Source.Power.Step.Increment = 1.0;

Specifies the step width in the appropriate path for POW:STEP:MODE USER. To adjust the level step-by-step with this increment value, use the command POW UP, or POW DOWN. Note: The command also sets Variation Step in the manual control, that means the user-defined step width for setting the level with the rotary knob or the Up/Down arrow keys.

increment: float