Source:Pm<GeneratorIxRepCap>#
RepCap Settings
// Range: Nr1 .. Nr8
var rc = driver.Source.Pm.RepCapGeneratorIx;
driver.Source.Pm.RepCapGeneratorIx = GeneratorIxRepCap.Nr1;
SCPI Commands
- [SOURce<HW>]:PM:MODE
- [SOURce<HW>]:PM:RATio
- [SOURce<HW>]:PM:SENSitivity
Cloning the Group
// Create a clone of the original group, that exists independently
var pm2 = driver.Source.Pm.Clone();
Direct SCPI Members
- PmModeEnum Mode
// SCPI: [SOURce<HW>]:PM:MODE PmModeEnum value = driver.Source.Pm.Mode; driver.Source.Pm.Mode = PmModeEnum.HBANdwidth;Selects the mode for the phase modulation.
mode: HBANdwidth | HDEViation | LNOise
HBANdwidth: Sets the maximum available bandwidth.
HDEViation: Sets the maximum range for ΦM deviation.
LNOise: Selects a phase modulation mode with phase noise and spurious characteristics close to CW mode.
- double Ratio
// SCPI: [SOURce<HW>]:PM:RATio double value = driver.Source.Pm.Ratio; driver.Source.Pm.Ratio = 1.0;Sets the deviation ratio (path2 to path1) in percent.
ratio: float
- double Sensitivity
// SCPI: [SOURce<HW>]:PM:SENSitivity double value = driver.Source.Pm.Sensitivity;Queries the sensitivity of the externally applied signal for phase modulation. The returned value reports the sensitivity in RAD/V. It is assigned to the voltage value for full modulation of the input.
sensitivity: float
Subgroups