Source:Iq#

SCPI Commands

[SOURce<HW>]:IQ:CREStfactor
[SOURce<HW>]:IQ:GAIN
[SOURce<HW>]:IQ:SOURce
[SOURce<HW>]:IQ:STATe
[SOURce<HW>]:IQ:WBSTate

Cloning the Group

// Create a clone of the original group, that exists independently
var iq2 = driver.Source.Iq.Clone();

Direct SCPI Members

double CrestFactor#
// SCPI: [SOURce<HW>]:IQ:CREStfactor
double value = driver.Source.Iq.CrestFactor;
driver.Source.Iq.CrestFactor = 1.0;

Specifies the crest factor for the external analog signal.

crestFactor: float


IqGainAllEnum Gain#
// SCPI: [SOURce<HW>]:IQ:GAIN
IqGainAllEnum value = driver.Source.Iq.Gain;
driver.Source.Iq.Gain = IqGainAllEnum.AUTO;

Sets the baseband gain for a wide dynamic range. You can amplify the baseband signal power level (positive gain) or attenuate this level (negative gain) to optimize the I/Q modulation performance. The optimization is a trade-off between signal distortion and signal-to-noise ratio (SNR) .


IqSourEnum Source#
// SCPI: [SOURce<HW>]:IQ:SOURce
IqSourEnum value = driver.Source.Iq.Source;
driver.Source.Iq.Source = IqSourEnum.ANALog;

Selects the input signal source for the I/Q modulator.

source: BASeband | | ANALog | DIFFerential

  • BASeband: Internal baseband signal

  • ANALog: External analog wideband I/Q signalEnabling the I/Q modulator disables an enabled amplitude modulation of the RF output signal.

  • Differential: External analog wideband I/Q signalEnabling the I/Q modulator disables an enabled amplitude modulation of the RF output signal.


bool State#
// SCPI: [SOURce<HW>]:IQ:STATe
bool value = driver.Source.Iq.State;
driver.Source.Iq.State = false;

Enables the I/Q modulation.

state: 1 | ON | 0| OFF


bool WbState#
// SCPI: [SOURce<HW>]:IQ:WBSTate
bool value = driver.Source.Iq.WbState;
driver.Source.Iq.WbState = false;

Activates I/Q wideband mode. Activation automatically optimizes the settings for wideband modulation signals with a bandwidth that is higher then 5 MHz.

wbState: 1 | ON | 0| OFF


Subgroups