Source:Frequency:Step#
SCPI Commands
- [SOURce<HW>]:FREQuency:STEP:MODE
- [SOURce<HW>]:FREQuency:STEP:[INCRement]
Direct SCPI Members
- FreqStepModeEnum Mode#
// SCPI: [SOURce<HW>]:FREQuency:STEP:MODE FreqStepModeEnum value = driver.Source.Frequency.Step.Mode; driver.Source.Frequency.Step.Mode = FreqStepModeEnum.DECimal;Defines the type of step size to vary the RF frequency at discrete steps with the commands FREQ UP or FREQ DOWN. You can define the step mode for each path separately.
mode: DECimal | USER
DECimal: Increases or decreases the level in steps of ten.
USER: Increases or decreases the level in increments, set with the command FREQ:STEP[:INCR].
- double Increment#
// SCPI: [SOURce<HW>]:FREQuency:STEP:[INCRement] double value = driver.Source.Frequency.Step.Increment; driver.Source.Frequency.Step.Increment = 1.0;Sets the step width. You can use this value to vary the RF frequency with command FREQ UP or FREQ DOWN. If you have activated FREQ:STEP:MODE USER. Note: This value also applies to the step width of the rotary knob on the instrument and, in user-defined step mode, increases or decreases the frequency.
increment: float