Source:Bb:Gsm:Pramp#

SCPI Commands

[SOURce<HW>]:BB:GSM:PRAMp:FDELay
[SOURce<HW>]:BB:GSM:PRAMp:RDELay
[SOURce<HW>]:BB:GSM:PRAMp:SHAPe
[SOURce<HW>]:BB:GSM:PRAMp:TIME

Cloning the Group

// Create a clone of the original group, that exists independently
var pramp2 = driver.Source.Bb.Gsm.Pramp.Clone();

Direct SCPI Members

double Fdelay#
// SCPI: [SOURce<HW>]:BB:GSM:PRAMp:FDELay
double value = driver.Source.Bb.Gsm.Pramp.Fdelay;
driver.Source.Bb.Gsm.Pramp.Fdelay = 1.0;

The command sets the offset in the Falling edge of the ramp envelope at the end of a slot. A positive value causes a ramp delay and a negative value advances the ramp. The setting is expressed in symbols.

fdelay: float


double Rdelay#
// SCPI: [SOURce<HW>]:BB:GSM:PRAMp:RDELay
double value = driver.Source.Bb.Gsm.Pramp.Rdelay;
driver.Source.Bb.Gsm.Pramp.Rdelay = 1.0;

The command sets the offset in the Rising edge of the ramp envelope at the start of a slot. A positive value causes a ramp delay and a negative value advances the ramp. The setting is expressed in symbols.

rdelay: float


RampFuncEnum Shape#
// SCPI: [SOURce<HW>]:BB:GSM:PRAMp:SHAPe
RampFuncEnum value = driver.Source.Bb.Gsm.Pramp.Shape;
driver.Source.Bb.Gsm.Pramp.Shape = RampFuncEnum.COSine;

The command sets the edge shape of the ramp envelope.

shape: LINear | COSine

  • LINear: The transmitted power rises and falls linear fashion.

  • COSine: The transmitted power rises and falls in the shape of a cosine.


double Time#
// SCPI: [SOURce<HW>]:BB:GSM:PRAMp:TIME
double value = driver.Source.Bb.Gsm.Pramp.Time;
driver.Source.Bb.Gsm.Pramp.Time = 1.0;

The command sets the edge slope of the ramp envelope. This specifies the number of symbols over which the switching operation is stretched when the transmitted power is turned on and off.

time: float


Subgroups