Source:Bb:C2K:Pparameter#

SCPI Commands

[SOURce<HW>]:BB:C2K:PPARameter:CRESt
[SOURce<HW>]:BB:C2K:PPARameter:RCONfiguration

Cloning the Group

// Create a clone of the original group, that exists independently
var pparameter2 = driver.Source.Bb.C2K.Pparameter.Clone();

Direct SCPI Members

CresFactModeEnum Crest#
// SCPI: [SOURce<HW>]:BB:C2K:PPARameter:CRESt
CresFactModeEnum value = driver.Source.Bb.C2K.Pparameter.Crest;
driver.Source.Bb.C2K.Pparameter.Crest = CresFactModeEnum.AVERage;

This command selects the desired range for the crest factor of the test scenario. The crest factor of the signal is kept in the desired range by automatically setting appropriate Walsh codes and timing offsets. The setting takes effect only after execution of command method RsSmw.Source.Bb.C2K.Pparameter.Execute.Set. The setting of command method RsSmw.Source.Bb.C2K.Bstation.Cgroup.Coffset.Wcode.Set is adjusted according to the selection.

crest: MINimum | AVERage | WORSt

  • MINimum: The crest factor is minimized. The Walsh codes are spaced as closely as possible.

  • AVERage: An average crest factor is set. The Walsh codes are distributed uniformly over the code domain.

  • WORSt: The crest factor is set to an unfavorable value (i.e. maximum) . The Walsh codes are as wildly spaced as possible.


Cdma2KradioConfEnum Rconfiguration#
// SCPI: [SOURce<HW>]:BB:C2K:PPARameter:RCONfiguration
Cdma2KradioConfEnum value = driver.Source.Bb.C2K.Pparameter.Rconfiguration;
driver.Source.Bb.C2K.Pparameter.Rconfiguration = Cdma2KradioConfEnum._1;

Selects the radio configuration for the traffic channel. The setting takes effect only after execution of command method RsSmw.Source.Bb.C2K.Pparameter.Execute.Set.

rconfiguration: 1 | 2| 3 | 4| 5


Subgroups