Source:Bb:C2K:Mstation:Mode#

SCPI Commands

[SOURce<HW>]:BB:C2K:MSTation<ST>:MODE

Direct SCPI Members

Cdma2KmsModeEnum Get ( )#
Cdma2KmsModeEnum Get ( MobileStationRepCap mobileStation )
void Set ( Cdma2KmsModeEnum mode )#
void Set ( Cdma2KmsModeEnum mode, MobileStationRepCap mobileStation )
// SCPI: [SOURce<HW>]:BB:C2K:MSTation<ST>:MODE
// Get:
Cdma2KmsModeEnum value = driver.Source.Bb.C2K.Mstation.Mode.Get();
Cdma2KmsModeEnum value = driver.Source.Bb.C2K.Mstation.Mode.Get(MobileStationRepCap.Default);
// Set:
driver.Source.Bb.C2K.Mstation.Mode.Set(Cdma2KmsModeEnum.ACCess, MobileStationRepCap.Default);
driver.Source.Bb.C2K.Mstation.Mode.Set(Cdma2KmsModeEnum.ACCess);

The command selects operating mode for the mobile station. The channel-specific parameters are set with commands SOUR:BB:C2K:MST<n>:CHANnel<n>:…n.

mode TRAFfic | ACCess | EACCess | CCONtrol

  • TRAFfic: The mobile station generates a single traffic channel A traffic channel consists of up to eight sub channels depending on the selected radio configuration (R-FCH, R-SCCH, R-SCH, R-DCCH) . This mode corresponds to the standard mode of a mobile station during voice and data transmission.

  • ACCess: The mobile station generates an access channel (R-ACH) . This channel is needed to set up the connection between the mobile station and the base station.

  • EACCess: The mobile station generates an enhanced access channel (R-ACH) and a pilot channel (R-PICH) .

  • CCONtrol: The mobile station generates a common control channel (R-ACH) and a pilot channel (R-PICH) .

mobileStation Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.