Source:Bb:C2K:Mstation:Ccoding:Mode#

SCPI Commands

[SOURce<HW>]:BB:C2K:MSTation<ST>:CCODing:MODE

Direct SCPI Members

Cdma2KcodModeEnum Get ( )#
Cdma2KcodModeEnum Get ( MobileStationRepCap mobileStation )
void Set ( Cdma2KcodModeEnum mode )#
void Set ( Cdma2KcodModeEnum mode, MobileStationRepCap mobileStation )
// SCPI: [SOURce<HW>]:BB:C2K:MSTation<ST>:CCODing:MODE
// Get:
Cdma2KcodModeEnum value = driver.Source.Bb.C2K.Mstation.Ccoding.Mode.Get();
Cdma2KcodModeEnum value = driver.Source.Bb.C2K.Mstation.Ccoding.Mode.Get(MobileStationRepCap.Default);
// Set:
driver.Source.Bb.C2K.Mstation.Ccoding.Mode.Set(Cdma2KcodModeEnum.COMPlete, MobileStationRepCap.Default);
driver.Source.Bb.C2K.Mstation.Ccoding.Mode.Set(Cdma2KcodModeEnum.COMPlete);

The command selects the channel coding mode.

mode OFF | COMPlete | NOINterleaving | OINTerleaving

  • OFF: Channel coding is deactivated.

  • COMPlete: The complete channel coding is performed. The channel coding procedure can slightly vary depending on channel type, frame length and data rate.

  • OINTerleaving: Except for the block interleaver, the whole channel coding procedure is carried out.

  • NOINterleaving: In this mode, only block interleaver is used for coding.

mobileStation Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.