Source:Bb:C2K:Bstation:Cgroup:Coffset:Ccoding:Mode#

SCPI Commands

[SOURce<HW>]:BB:C2K:BSTation<ST>:CGRoup<DI0>:COFFset<CH>:CCODing:MODE

Direct SCPI Members

Cdma2KcodModeEnum Get ( )#
Cdma2KcodModeEnum Get ( BaseStationRepCap baseStation, GroupNullRepCap groupNull, OffsetRepCap offset )
void Set ( Cdma2KcodModeEnum mode )#
void Set ( Cdma2KcodModeEnum mode, BaseStationRepCap baseStation, GroupNullRepCap groupNull, OffsetRepCap offset )
// SCPI: [SOURce<HW>]:BB:C2K:BSTation<ST>:CGRoup<DI0>:COFFset<CH>:CCODing:MODE
// Get:
Cdma2KcodModeEnum value = driver.Source.Bb.C2K.Bstation.Cgroup.Coffset.Ccoding.Mode.Get();
Cdma2KcodModeEnum value = driver.Source.Bb.C2K.Bstation.Cgroup.Coffset.Ccoding.Mode.Get(BaseStationRepCap.Default, GroupNullRepCap.Default, OffsetRepCap.Default);
// Set:
driver.Source.Bb.C2K.Bstation.Cgroup.Coffset.Ccoding.Mode.Set(Cdma2KcodModeEnum.COMPlete, BaseStationRepCap.Default, GroupNullRepCap.Default, OffsetRepCap.Default);
driver.Source.Bb.C2K.Bstation.Cgroup.Coffset.Ccoding.Mode.Set(Cdma2KcodModeEnum.COMPlete);

Selects channel coding mode. For the traffic channels, this value is specific for the selected radio configuration.

mode OFF | COMPlete | NOINterleaving | OINTerleaving

  • OFF: Channel coding is deactivated.

  • COMPlete: The complete channel coding is performed. The channel coding procedure can slightly vary depending on channel type, frame length and data rate.

  • OINTerleaving: Except for the block interleaver, the whole channel coding procedure is carried out. In this mode, the frame structure and the convolutional coder of a receiver can be tested.

  • NOINterleaving: In this mode, only block interleaver is used for coding. This allows the deinterleaver in the receiver to be tested independently of the remaining (de-) coding process.

baseStation Repeated capability selector

groupNull Repeated capability selector

offset Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.