Output:User:Signal#

SCPI Commands

OUTPut<HW>:USER<CH>:SIGNal

Direct SCPI Members

OutpConnGlbSignalEnum Get ( )#
OutpConnGlbSignalEnum Get ( UserIxRepCap userIx )
void Set ( OutpConnGlbSignalEnum signal )#
void Set ( OutpConnGlbSignalEnum signal, UserIxRepCap userIx )
// SCPI: OUTPut<HW>:USER<CH>:SIGNal
// Get:
OutpConnGlbSignalEnum value = driver.Output.User.Signal.Get();
OutpConnGlbSignalEnum value = driver.Output.User.Signal.Get(UserIxRepCap.Default);
// Set:
driver.Output.User.Signal.Set(OutpConnGlbSignalEnum.BERCLKOUT, UserIxRepCap.Default);
driver.Output.User.Signal.Set(OutpConnGlbSignalEnum.BERCLKOUT);

Sets the control signal that is output at the selected connector. To define the connector direction, use the command method RsSmw.Output.User.Direction.Set.

signal MARKA | B|C | D1 | 2|3 = Baseband BB Marker 1/2/3 (available marker signals depend on the system configuration, see Table “Mapping control signals to the USER x connectors”) SVALA | SVALB = Signal Valid A/B, available for USER4 | 5|6 SVALANegated | SVALBNegated = Signal Valid A/B (negative) , available for USER4 | 5|6 OPULSA | OPULSB = Pulse Out A/B, available for USER4 | 5|6 SYNCA | SYNCB = Pulse Sync A/B, available for USER4 | 5|6 VIDEOA | VIDEOB = Pulse Video A/B, available for USER4 | 5|6 MTRigger = Manual Trigger, available for USER6 RTRIGA | RTRIGB = REG trigger A/B, available for USER4 | 5 BERRESTOUT | BERDATENOUT | BERCLKOUT | BERDATOUT = BERT TestGen Data, Clock, Data Enable and Restart SYNCOUT = Baseband Sync Out LOW | HIGH = Always 0/1 NONE = none

userIx Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.