Fixed

SCPI Commands :

[SOURce<HW>]:FREQuency:[FIXed]:RCL
[SOURce<HW>]:FREQuency:[FIXed]
class FixedCls[source]

Fixed commands group definition. 2 total commands, 0 Subgroups, 2 group commands

get_recall() → RsSmbv.enums.InclExcl[source]
# SCPI: [SOURce<HW>]:FREQuency:[FIXed]:RCL
value: enums.InclExcl = driver.source.frequency.fixed.get_recall()

Set whether the RF frequency value is retained or taken from a loaded instrument configuration, when you recall instrument settings with command *RCL.

return

rcl: INCLude| EXCLude INCLude Takes the frequency value of the loaded settings. EXCLude Retains the current frequency when an instrument configuration is loaded.

get_value() → float[source]
# SCPI: [SOURce<HW>]:FREQuency:[FIXed]
value: float = driver.source.frequency.fixed.get_value()
Sets the frequency of the RF output signal in the selected path.

INTRO_CMD_HELP: The effect depends on the selected mode:

  • In CW mode (FREQ:MODE CW | FIXed) , the instrument operates at a fixed frequency.

  • In sweep mode (FREQ:MODE SWE) , the value applies to the sweep frequency. The instrument processes the frequency settings in defined sweep steps.

  • In user mode (FREQ:STEP:MODE USER) , you can vary the current frequency step by step.

return

fixed: float The following settings influence the value range: An offset set with the command [:SOURcehw]:FREQuency:OFFSet Numerical value Sets the frequency in CW and sweep mode UP|DOWN Varies the frequency step by step in user mode. The frequency is increased or decreased by the value set with the command [:SOURcehw]:FREQuency:STEP[:INCRement]. Range: (RFmin + OFFSet) to (RFmax + OFFSet)

set_recall(rcl: RsSmbv.enums.InclExcl) → None[source]
# SCPI: [SOURce<HW>]:FREQuency:[FIXed]:RCL
driver.source.frequency.fixed.set_recall(rcl = enums.InclExcl.EXCLude)

Set whether the RF frequency value is retained or taken from a loaded instrument configuration, when you recall instrument settings with command *RCL.

param rcl

INCLude| EXCLude INCLude Takes the frequency value of the loaded settings. EXCLude Retains the current frequency when an instrument configuration is loaded.

set_value(fixed: float) → None[source]
# SCPI: [SOURce<HW>]:FREQuency:[FIXed]
driver.source.frequency.fixed.set_value(fixed = 1.0)
Sets the frequency of the RF output signal in the selected path.

INTRO_CMD_HELP: The effect depends on the selected mode:

  • In CW mode (FREQ:MODE CW | FIXed) , the instrument operates at a fixed frequency.

  • In sweep mode (FREQ:MODE SWE) , the value applies to the sweep frequency. The instrument processes the frequency settings in defined sweep steps.

  • In user mode (FREQ:STEP:MODE USER) , you can vary the current frequency step by step.

param fixed

float The following settings influence the value range: An offset set with the command [:SOURcehw]:FREQuency:OFFSet Numerical value Sets the frequency in CW and sweep mode UP|DOWN Varies the frequency step by step in user mode. The frequency is increased or decreased by the value set with the command [:SOURcehw]:FREQuency:STEP[:INCRement]. Range: (RFmin + OFFSet) to (RFmax + OFFSet)