DmOffset

SCPI Command :

[SENSe]:PROBe<pb>:SETup:DMOFfset

class DmOffsetCls

DmOffset commands group definition. 1 total commands, 0 Subgroups, 1 group commands

get(probe=Probe.Default) → float

# SCPI: [SENSe]:PROBe<pb>:SETup:DMOFfset
value: float = driver.sense.probe.setup.dmOffset.get(probe = repcap.Probe.Default)

Sets the DM-mode offset. The setting is only available if a modular probe in DM-mode is connected to the FSW. If the probe is disconnected, the DM-mode offset of the probe is reset to 0.0 V. Note that if the offset for DM-mode or CM-mode is changed, the offsets for the P-mode and N-mode are adapted accordingly, and vice versa. For details see ‘Using Probes’.

param probe

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)

return

dm_offset: Voltage offset between the positive and negative input terminal Unit: V

set(dm_offset: float, probe=Probe.Default) → None

# SCPI: [SENSe]:PROBe<pb>:SETup:DMOFfset
driver.sense.probe.setup.dmOffset.set(dm_offset = 1.0, probe = repcap.Probe.Default)

Sets the DM-mode offset. The setting is only available if a modular probe in DM-mode is connected to the FSW. If the probe is disconnected, the DM-mode offset of the probe is reset to 0.0 V. Note that if the offset for DM-mode or CM-mode is changed, the offsets for the P-mode and N-mode are adapted accordingly, and vice versa. For details see ‘Using Probes’.

param dm_offset

Voltage offset between the positive and negative input terminal Unit: V

param probe

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Probe’)