Result

SCPI Command :

[SENSe]:ADEMod:FM[:TDOMain]:RESult
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(trace_mode: TraceModeB) → float[source]
# [SENSe]:ADEMod:FM[:TDOMain]:RESult
value: float = driver.sense.ademod.fm.tdomain.result.get(trace_mode = enums.TraceModeB.AVERage)

Reads the result data of the evaluated signal in the specified trace mode. The data format of the output data block is defined by the FORMat command (see method RsFsw.formatPy.data.set() ) . The trace results are configured for a specific evaluation. The following table indicates which command syntax refers to which evaluation method, as well as the output unit of the results. Command syntax / Evaluation method / Output unit

  • ACV[:TDOMain] / AC-Video time domain / V

  • ACV:AFSpectrum / AC-Video spectrum / V

  • AM[:ABSolute][:TDOMain] / RF time domain / dBm

  • AM:RELative[:TDOMain] / AM time domain / %

  • AM:RELative:AFSPectrum / AM spectrum / %

  • FM[:TDOMain] / FM time domain / kHz

  • FM:AFSPectrum / FM spectrum / kHz

  • PM[:TDOMain] / PM time domain / rad or °

  • PM:AFSPectrum / PM spectrum / rad or °

  • SPECtrum / RF spectrum / dBm (logarithmic display) or V (linear display) .

Parameters:

trace_mode – WRITe | AVERage | MAXHold | MINHold

Returns:

trace_mode_result: The specified trace mode must be one of those configured by SENS:ADEM:Evaluation:TYPE, see method RsFsw.sense.ademod.spectrum.typePy.set() . Otherwise a query error is generated.