Result

SCPI Command :

[SENSe]:ADEMod:ACV[:TDOMain]:RESult
class ResultCls[source]

Result commands group definition. 1 total commands, 0 Subgroups, 1 group commands

get(trace_mode: RsFsw.enums.TraceModeB) → float[source]
# SCPI: [SENSe]:ADEMod:ACV[:TDOMain]:RESult
value: float = driver.sense.ademod.acv.tdomain.result.get(trace_mode = enums.TraceModeB.AVERage)

Reads the result data of the evaluated signal in the specified trace mode. The data format of the output data block is defined by the FORMat command (see method RsFsw.FormatPy.Data.set) . The trace results are configured for a specific evaluation. The following table indicates which command syntax refers to which evaluation method, as well as the output unit of the results.

Table Header: Command syntax / Evaluation method / Output unit

  • ACV[:TDOMain] / AC-Video time domain / V

  • ACV:AFSpectrum / AC-Video spectrum / V

  • AM[:ABSolute][:TDOMain] / RF time domain / dBm

  • AM:RELative[:TDOMain] / AM time domain / %

  • AM:RELative:AFSPectrum / AM spectrum / %

  • FM[:TDOMain] / FM time domain / kHz

  • FM:AFSPectrum / FM spectrum / kHz

  • PM[:TDOMain] / PM time domain / rad or °

  • PM:AFSPectrum / PM spectrum / rad or °

  • SPECtrum / RF spectrum / dBm (logarithmic display) or V (linear display) .

param trace_mode

WRITe | AVERage | MAXHold | MINHold

return

trace_mode_result: The specified trace mode must be one of those configured by SENS:ADEM:Evaluation:TYPE, see [SENSe:]ADEMod:SPECtrum[:TYPE]. Otherwise a query error is generated.