Select

SCPI Command :

DIAGnostic:SERVice:INPut[:SELect]

Commands in total: 1
Subgroups: 0
Direct child commands: 1

set(signal: DiagnosticSignal) → None[source]

# DIAGnostic:SERVice:INPut[:SELect]
driver.diagnostic.service.inputPy.select.set(signal = enums.DiagnosticSignal.AIQ)

This command activates or deactivates the use of an internal calibration signal as input for the FSW.

Parameters:: signal – CALibration Uses the calibration signal as RF input. MCALibration Uses the calibration signal for the microwave range as RF input. RF Uses the signal from the RF input. AIQ Uses the analog baseband calibration signal as input to the optional ‘Analog Baseband’ interface. This signal is only available if the option is installed.