MeastoRef<RefMeasurement>

RepCap Settings

# Range: Nr1 .. Nr32
rc = driver.configure.ademod.results.am.detector.reference.meastoRef.repcap_refMeasurement_get()
driver.configure.ademod.results.am.detector.reference.meastoRef.repcap_refMeasurement_set(repcap.RefMeasurement.Nr1)

SCPI Command :

CONFigure:ADEMod:RESults:AM:DETector<det>:REFerence:MEAStoref<t>

class MeastoRefCls

MeastoRef commands group definition. 1 total commands, 0 Subgroups, 1 group commands Repeated Capability: RefMeasurement, default value after init: RefMeasurement.Nr1

set(trace=Trace.Default, refMeasurement=RefMeasurement.Default) → None

# SCPI: CONFigure:ADEMod:RESults:AM:DETector<det>:REFerence:MEAStoref<t>
driver.configure.ademod.results.am.detector.reference.meastoRef.set(trace = repcap.Trace.Default, refMeasurement = repcap.RefMeasurement.Default)

Sets the reference value to be used for relative demodulation results to the currently measured value on the specified trace for all relative detectors. If necessary, the detectors are activated. A reference value 0 would provide infinite results and is thus automatically corrected to 0.1.

param trace

optional repeated capability selector. Default value: Tr1 (settable in the interface ‘Detector’)

param refMeasurement

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘MeastoRef’)

set_with_opc(trace=Trace.Default, refMeasurement=RefMeasurement.Default, opc_timeout_ms: int = - 1) → None

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.configure.ademod.results.am.detector.reference.meastoRef.clone()