Address<Antenna>

RepCap Settings

# Range: Nr1 .. Nr32
rc = driver.applications.k91Wlan.configure.wlan.antMatrix.address.repcap_antenna_get()
driver.applications.k91Wlan.configure.wlan.antMatrix.address.repcap_antenna_set(repcap.Antenna.Nr1)

SCPI Command :

CONFigure:WLAN:ANTMatrix:ADDRess<ant>

class AddressCls

Address commands group definition. 1 total commands, 0 Subgroups, 1 group commands Repeated Capability: Antenna, default value after init: Antenna.Nr1

get(antenna=Antenna.Default) → str

# SCPI: CONFigure:WLAN:ANTMatrix:ADDRess<ant>
value: str = driver.applications.k91Wlan.configure.wlan.antMatrix.address.get(antenna = repcap.Antenna.Default)

This remote control command specifies the TCP/IP address for each receiver path in IPV4 format. Note, it is not possible to set the IP address of ANTMatrix1 (primary)

param antenna

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Address’)

return

address: TCP/IP address in IPV4 format

set(address: str, antenna=Antenna.Default) → None

# SCPI: CONFigure:WLAN:ANTMatrix:ADDRess<ant>
driver.applications.k91Wlan.configure.wlan.antMatrix.address.set(address = 'abc', antenna = repcap.Antenna.Default)

This remote control command specifies the TCP/IP address for each receiver path in IPV4 format. Note, it is not possible to set the IP address of ANTMatrix1 (primary)

param address

TCP/IP address in IPV4 format

param antenna

optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Address’)

Cloning the Group

# Create a clone of the original group, that exists independently
group2 = driver.applications.k91Wlan.configure.wlan.antMatrix.address.clone()