Immediate

SCPI Command :

CONFigure:BURSt:EVM:EVCHip[:IMMediate]

Commands in total: 1
Subgroups: 0
Direct child commands: 1

perform(opc_timeout_ms: int = -1) → None[source]

# CONFigure:BURSt:EVM:EVCHip[:IMMediate]
driver.applications.k91Wlan.configure.burst.evm.evChip.immediate.perform()

Both of these commands configure the measurement type to be ‘EVM vs Chip’ for IEEE 802.11b and g (DSSS) standards. For compatibility reasons, the method RsFsw.applications.k91Wlan.configure.burst.evm.esymbol.immediate.perform() command is also supported for the IEEE 802.11b and g (DSSS) standards. However, for new remote control programs use the LAYout commands (see ‘Working with windows in the display’) . Results are only displayed after a measurement is executed, e.g. using the method RsFsw.applications.k10Xlte.initiate.immediate.perform() command. Note that the CONF:BURS:<ResultType>:IMM commands change the screen layout to display the ‘Magnitude Capture’ buffer in window 1 at the top of the screen and the selected result type in window 2 below that. Any other active windows are closed. Use the LAYout commands to change the display (see ‘Working with windows in the display’) .

Parameters:: opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.