End

SCPI Command :

CALCulate<n>:HOPDetection:POWer:OFFSet:END

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get(window=Window.Default) → float

# CALCulate<n>:HOPDetection:POWer:OFFSet:END
value: float = driver.applications.k60Transient.calculate.hopDetection.power.offset.end.get(window = repcap.Window.Default)

Defines the end of the measurement range as an offset in seconds from the hop end. This command is only available if the reference is EDGE (see method RsFsw.applications.k60Transient.calculate.hopDetection.power.reference.set() ) . For details on the measurement range parameters see ‘Measurement range’.

Parameters:

window – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)

Returns:

time: Unit: S

set(time: float, window=Window.Default) → None

# CALCulate<n>:HOPDetection:POWer:OFFSet:END
driver.applications.k60Transient.calculate.hopDetection.power.offset.end.set(time = 1.0, window = repcap.Window.Default)

Defines the end of the measurement range as an offset in seconds from the hop end. This command is only available if the reference is EDGE (see method RsFsw.applications.k60Transient.calculate.hopDetection.power.reference.set() ) . For details on the measurement range parameters see ‘Measurement range’.

Parameters:

• time – Unit: S

• window – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Calculate’)