All

SCPI Command :

CONFigure:DPD:FILE:GENerate:ALL
Commands in total: 1
Subgroups: 0
Direct child commands: 1
set() → None[source]
# CONFigure:DPD:FILE:GENerate:ALL
driver.applications.k18AmplifierEt.configure.dpd.file.generate.all.set()

This command generates the waveform files containing predistortion information within the amplifier application. All in all, the command generates three waveform files: ‘AM/AM’ only, ‘AM/PM’ only and ‘AM/AM’ plus ‘AM/PM’. It also transfers these waveform files to the connected signal generator and turns on the ‘AM/AM’ and ‘AM/PM’ DPDs. Alternatively, you can do that with:

  • method RsFsw.applications.k18AmplifierEt.configure.dpd.file.generate.set() and

  • method RsFsw.applications.k18AmplifierEt.configure.dpd.amxm.state.set()

Prerequisites for this command

  • Turn on polynomial DPD (method RsFsw.applications.k18AmplifierEt.configure.ddpd.state.set() ) .

set_with_opc(opc_timeout_ms: int = -1) → None[source]
# CONFigure:DPD:FILE:GENerate:ALL
driver.applications.k18AmplifierEt.configure.dpd.file.generate.all.set_with_opc()

This command generates the waveform files containing predistortion information within the amplifier application. All in all, the command generates three waveform files: ‘AM/AM’ only, ‘AM/PM’ only and ‘AM/AM’ plus ‘AM/PM’. It also transfers these waveform files to the connected signal generator and turns on the ‘AM/AM’ and ‘AM/PM’ DPDs. Alternatively, you can do that with:

  • method RsFsw.applications.k18AmplifierEt.configure.dpd.file.generate.set() and

  • method RsFsw.applications.k18AmplifierEt.configure.dpd.amxm.state.set()

Prerequisites for this command

  • Turn on polynomial DPD (method RsFsw.applications.k18AmplifierEt.configure.ddpd.state.set() ) .

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.