Value

SCPI Command :

INPut:GAIN[:VALue]

Commands in total: 1

Subgroups: 0

Direct child commands: 1

get() → float

# INPut:GAIN[:VALue]
value: float = driver.applications.k14Xnr5G.inputPy.gain.value.get()

Selects the ‘gain’ if the preamplifier is activated (INP:GAIN:STAT ON, see method RsFsw.applications.k10Xlte.inputPy.gain.state.set() ) . The command requires the additional preamplifier hardware option.

set(arg_0: float) → None

# INPut:GAIN[:VALue]
driver.applications.k14Xnr5G.inputPy.gain.value.set(arg_0 = 1.0)

Selects the ‘gain’ if the preamplifier is activated (INP:GAIN:STAT ON, see method RsFsw.applications.k10Xlte.inputPy.gain.state.set() ) . The command requires the additional preamplifier hardware option.

Parameters:

arg_0 – For all FSW models except for FSW85, the following settings are available: 15 dB and 30 dB All other values are rounded to the nearest of these two. 30 dB For older FSW43/FSW50/FSW67 models, the input signal is always ampilfied by about 30 dB when the preamplifier is active. For FSW85 models, no preamplifier is available. Unit: DB