Rf

SCPI Command :

CONFigure:GENerator:SETTings:UPDate:RF
Commands in total: 1
Subgroups: 0
Direct child commands: 1
set() → None[source]
# CONFigure:GENerator:SETTings:UPDate:RF
driver.applications.k14Xnr5G.configure.generator.settings.update.rf.set()

Uploads the RF settings (frequency, level) from analyzer to the generator. Prerequisites for this command

  • IP connection to a signal generator.

  • Generator control state is on (method RsFsw.applications.k18AmplifierEt.configure.generator.control.state.set() ) .

set_with_opc(opc_timeout_ms: int = -1) → None[source]
# CONFigure:GENerator:SETTings:UPDate:RF
driver.applications.k14Xnr5G.configure.generator.settings.update.rf.set_with_opc()

Uploads the RF settings (frequency, level) from analyzer to the generator. Prerequisites for this command

  • IP connection to a signal generator.

  • Generator control state is on (method RsFsw.applications.k18AmplifierEt.configure.generator.control.state.set() ) .

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.