Stop

SCPI Command :

[SENSe]:ESPectrum<sb>:RANGe<ri>:FREQuency:STOP
Commands in total: 1
Subgroups: 0
Direct child commands: 1
get(subBlock=SubBlock.Default, rangePy=RangePy.Default) → float[source]
# [SENSe]:ESPectrum<sb>:RANGe<ri>:FREQuency:STOP
value: float = driver.applications.k10Xlte.sense.espectrum.range.frequency.stop.get(subBlock = repcap.SubBlock.Default, rangePy = repcap.RangePy.Default)

Defines the stop frequency of a SEM range. Make sure to set an appropriate span. If you set a span that is The following signal characteristics are automatically detected.

  • smaller than the span the SEM sweep list covers, the FSW will not measure the ranges that are outside the span - results may be invalid.

  • greater than the span the SEM sweep list covers, the FSW will adjust the start frequency of the first SEM range and the stop frequency of the last SEM range to the span

For more information see ‘Ranges and range settings’.

Parameters:

  • subBlock – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Espectrum’)

  • rangePy – optional repeated capability selector. Default value: Ix1 (settable in the interface ‘Range’)

Returns:

frequency: Numeric value. Unit: Hz

set(frequency: float, subBlock=SubBlock.Default, rangePy=RangePy.Default) → None[source]
# [SENSe]:ESPectrum<sb>:RANGe<ri>:FREQuency:STOP
driver.applications.k10Xlte.sense.espectrum.range.frequency.stop.set(frequency = 1.0, subBlock = repcap.SubBlock.Default, rangePy = repcap.RangePy.Default)

Defines the stop frequency of a SEM range. Make sure to set an appropriate span. If you set a span that is The following signal characteristics are automatically detected.

  • smaller than the span the SEM sweep list covers, the FSW will not measure the ranges that are outside the span - results may be invalid.

  • greater than the span the SEM sweep list covers, the FSW will adjust the start frequency of the first SEM range and the stop frequency of the last SEM range to the span

For more information see ‘Ranges and range settings’.

Parameters:

  • frequency – Numeric value. Unit: Hz

  • subBlock – optional repeated capability selector. Default value: Nr1 (settable in the interface ‘Espectrum’)

  • rangePy – optional repeated capability selector. Default value: Ix1 (settable in the interface ‘Range’)