Source:Regenerator:Simulation:Calibration#

SCPI Commands

[SOURce<HW>]:REGenerator:SIMulation:CALibration:CORRection
[SOURce<HW>]:REGenerator:SIMulation:CALibration:MODE
[SOURce<HW>]:REGenerator:SIMulation:CALibration:URANge
[SOURce<HW>]:REGenerator:SIMulation:CALibration:[STATe]

Cloning the Group

// Create a clone of the original group, that exists independently
var calibration2 = driver.Source.Regenerator.Simulation.Calibration.Clone();

Direct SCPI Members

double Correction#
// SCPI: [SOURce<HW>]:REGenerator:SIMulation:CALibration:CORRection
double value = driver.Source.Regenerator.Simulation.Calibration.Correction;
driver.Source.Regenerator.Simulation.Calibration.Correction = 1.0;

Adds a correction to the automatically estimated system latency value.

corrValue: float


RegSimCalibrationModeEnum Mode#
// SCPI: [SOURce<HW>]:REGenerator:SIMulation:CALibration:MODE
RegSimCalibrationModeEnum value = driver.Source.Regenerator.Simulation.Calibration.Mode;
driver.Source.Regenerator.Simulation.Calibration.Mode = RegSimCalibrationModeEnum.AUTomatic;

Sets how the system latency is estimated.

calMode: AUTomatic mode can be used only if a R&S FSW is connected to the R&S SMW200A.


bool Urange#
// SCPI: [SOURce<HW>]:REGenerator:SIMulation:CALibration:URANge
bool value = driver.Source.Regenerator.Simulation.Calibration.Urange;
driver.Source.Regenerator.Simulation.Calibration.Urange = false;

Allows you to simulate objects at a range closer than 2.1 km.

useUnderRange: 1 | ON | 0| OFF


RegSimCalibrationStateEnum State#
// SCPI: [SOURce<HW>]:REGenerator:SIMulation:CALibration:[STATe]
RegSimCalibrationStateEnum value = driver.Source.Regenerator.Simulation.Calibration.State;

Queries the status of the automatic system calibration process.

calibrationStat: FAILed | SUCCess


Subgroups