Source:Fsimulator:Iloss#

SCPI Commands

[SOURce<HW>]:FSIMulator:ILOSs:CSAMples
[SOURce<HW>]:FSIMulator:ILOSs:MODE
[SOURce<HW>]:FSIMulator:ILOSs:[LOSS]

Direct SCPI Members

double Csamples#
// SCPI: [SOURce<HW>]:FSIMulator:ILOSs:CSAMples
double value = driver.Source.Fsimulator.Iloss.Csamples;

Queries the share of samples which were clipped due to the insertion loss setting.

csamples: string


FadInsLossModeEnum Mode#
// SCPI: [SOURce<HW>]:FSIMulator:ILOSs:MODE
FadInsLossModeEnum value = driver.Source.Fsimulator.Iloss.Mode;
driver.Source.Fsimulator.Iloss.Mode = FadInsLossModeEnum.LACP;

Sets the insertion loss of the fading simulator.

mode: NORMal | LACP | USER

  • NORMal: The minimum insertion loss for a path of the fading simulator is set to a fixed value of 18 dB.

  • LACP: The minimum insertion loss is between 6 dB and 12 dB. This value is dependent upon the Path Loss setting of the fading paths which are switched on. Low ACP mode is only recommended for fading paths with Raleigh profile. Only in this case a statistical distribution of level fluctuation is ensured. For other fading profiles, non-statistical level fluctuations occur which lead to an enormous increase of clipping. However, monitoring the percentage of clipped samples is recommended for Raleigh paths also.

  • USER: Any value for the minimum insertion loss in the range from 0 dB to 18 dB can be selected. Enter the value using the :SOURce1:FSIMulator:ILOSs:LOSS command.


double Loss#
// SCPI: [SOURce<HW>]:FSIMulator:ILOSs:[LOSS]
double value = driver.Source.Fsimulator.Iloss.Loss;
driver.Source.Fsimulator.Iloss.Loss = 1.0;

Sets the user-defined insertion loss of the fading simulator when User is selected. In the Normal and Low ACP modes, the current setting of the value can be queried.

loss: float