Source:Fm<GeneratorIxRepCap>#

RepCap Settings

// Range: Nr1 .. Nr8
var rc = driver.Source.Fm.RepCapGeneratorIx;
driver.Source.Fm.RepCapGeneratorIx = GeneratorIxRepCap.Nr1;

SCPI Commands

[SOURce<HW>]:FM:MODE
[SOURce<HW>]:FM:RATio
[SOURce<HW>]:FM:SENSitivity

Cloning the Group

// Create a clone of the original group, that exists independently
var fm2 = driver.Source.Fm.Clone();

Direct SCPI Members

FmModeEnum Mode
// SCPI: [SOURce<HW>]:FM:MODE
FmModeEnum value = driver.Source.Fm.Mode;
driver.Source.Fm.Mode = FmModeEnum.LNOise;

Selects the mode for the frequency modulation.

mode: NORMal | LNOise

  • NORMal: The maximum range for modulation bandwidth and FM deviation is available.

  • LNOise: Frequency modulation with phase noise and spurious characteristics close to CW mode. The range for modulation bandwidth and FM deviation is reduced (see the specifications document) .


double Ratio
// SCPI: [SOURce<HW>]:FM:RATio
double value = driver.Source.Fm.Ratio;
driver.Source.Fm.Ratio = 1.0;

Sets the deviation ratio (path2 to path1) in percent.

ratio: float


double Sensitivity
// SCPI: [SOURce<HW>]:FM:SENSitivity
double value = driver.Source.Fm.Sensitivity;

Queries the sensitivity of the externally supplied signal for frequency modulation. The sensitivity depends on the set modulation deviation.

sensitivity: Sensitivity in Hz/V. It is assigned to the voltage value for full modulation of the input.


Subgroups