Source:Correction:Optimize:Rf:Coffset#

SCPI Commands

[SOURce<HW>]:CORRection:OPTimize:RF:COFFset
[SOURce<HW>]:CORRection:OPTimize:RF:COFFset:VALue

Direct SCPI Members

bool Enabled#
// SCPI: [SOURce<HW>]:CORRection:OPTimize:RF:COFFset
bool value = driver.Source.Correction.Optimize.Rf.Coffset.Enabled;
driver.Source.Correction.Optimize.Rf.Coffset.Enabled = false;

If enabled, you can only route each stream to one output. Routing multiple streams to one output or one stream to multiple outputs is not allowed with an enabled carrier offset. The carrier offset relates to the bandwidth bsignal of the I/Q signal as follows: fc_offset = 20 MHz + bsignal/2 If no signal bandwidth is available, the carrier offset calculation uses the sample rate rsample instead of the bandwidth: fc_offset = 20 MHz + rsample/2

state: 0 | 1| OFF | ON


double Value#
// SCPI: [SOURce<HW>]:CORRection:OPTimize:RF:COFFset:VALue
double value = driver.Source.Correction.Optimize.Rf.Coffset.Value;

If a carrier offset is enabled, the command queries the value of the current carrier offset. This value depends on the bandwidth bsignal of the I/Q signal or the baseband sample rate rsample.

currentCarrOffs: float