Source:Awgn#

SCPI Commands

[SOURce<HW>]:AWGN:BRATe
[SOURce<HW>]:AWGN:CNRatio
[SOURce<HW>]:AWGN:ENRatio
[SOURce<HW>]:AWGN:MODE
[SOURce<HW>]:AWGN:STATe

Cloning the Group

// Create a clone of the original group, that exists independently
var awgn2 = driver.Source.Awgn.Clone();

Direct SCPI Members

double Brate#
// SCPI: [SOURce<HW>]:AWGN:BRATe
double value = driver.Source.Awgn.Brate;
driver.Source.Awgn.Brate = 1.0;

Sets the bit rate used for calculation of bit energy to noise power ratio. Valid units are bps, kbps and mabps as well as b/s, kb/s and mab/s.

brate: float


double CnRatio#
// SCPI: [SOURce<HW>]:AWGN:CNRatio
double value = driver.Source.Awgn.CnRatio;
driver.Source.Awgn.CnRatio = 1.0;

Sets the carrier/interferer ratio.

cnRatio: float


double EnRatio#
// SCPI: [SOURce<HW>]:AWGN:ENRatio
double value = driver.Source.Awgn.EnRatio;
driver.Source.Awgn.EnRatio = 1.0;

Sets the ratio of bit energy to noise power density.

enRatio: float


NoisAwgnModeEnum Mode#
// SCPI: [SOURce<HW>]:AWGN:MODE
NoisAwgnModeEnum value = driver.Source.Awgn.Mode;
driver.Source.Awgn.Mode = NoisAwgnModeEnum.ADD;

Determines how the interfering signal is generated.

mode: ONLY | ADD | CW

  • ADD: The AWGN noise signal is added to the baseband signal.

  • ONLY: The pure AWGN noise signal is modulated to the carrier. The connection to the baseband is interrupted

  • CW: The sine interfering signal is added to the baseband signal.


bool State#
// SCPI: [SOURce<HW>]:AWGN:STATe
bool value = driver.Source.Awgn.State;
driver.Source.Awgn.State = false;

Activates or deactivates the AWGN generator or the corresponding stream. See also “Suffixes in the keywords ENTity<ch> and SOURce<hw>”.

state: 1 | ON | 0| OFF


Subgroups