Sense:Power:Zero#

SCPI Commands

SENSe<CH>:[POWer]:ZERO

Direct SCPI Members

void Set ( ChannelRepCap channel )#
void SetAndWait ( ChannelRepCap channel )#
void SetAndWait ( ChannelRepCap channel, int opcTimeoutMs )
// SCPI: SENSe<CH>:[POWer]:ZERO
driver.Sense.Power.Zero.Set(ChannelRepCap.Default);
driver.Sense.Power.Zero.SetAndWait(ChannelRepCap.Default);
driver.Sense.Power.Zero.SetAndWait(ChannelRepCap.Default, 1000);

Performs zeroing of the sensor. Zeroing is required after warm-up, i.e. after connecting the sensor. Note: Switch off or disconnect the RF power source from the sensor before zeroing. We recommend that you zero in regular intervals (at least once a day) , if:

  • The temperature has varied more than about 5 °C.

  • The sensor has been replaced.

  • You want to measure very low power.

channel Repeated capability selector

SetAndWait is the same as Set, but waits for the operation to complete. The optional entered opcTimeoutMs is only valid for this call. If you omit the opcTimeoutMs, the method uses the settable value RsSmw.Utilities.OpcTimeout.