Sconfiguration:Output:Mapping:Stream:Foffset#

SCPI Commands

SCONfiguration:OUTPut:MAPPing:STReam<ST>:FOFFset

Direct SCPI Members

double Get ( )#
double Get ( StreamRepCap stream )
void Set ( double smFreqOffset )#
void Set ( double smFreqOffset, StreamRepCap stream )
// SCPI: SCONfiguration:OUTPut:MAPPing:STReam<ST>:FOFFset
// Get:
double value = driver.Sconfiguration.Output.Mapping.Stream.Foffset.Get();
double value = driver.Sconfiguration.Output.Mapping.Stream.Foffset.Get(StreamRepCap.Default);
// Set:
driver.Sconfiguration.Output.Mapping.Stream.Foffset.Set(1.0, StreamRepCap.Default);
driver.Sconfiguration.Output.Mapping.Stream.Foffset.Set(1.0);

For wideband instruments (R&S SMW-B9) , this settings requires analog signal outputs: SCONfiguration:OUTPut:MODE ANAL Sets the frequency offset per stream. This offset implies a shift in the frequency domain for all signals that the stream routes to a specific output connector. For example, RF or I/Q output connectors. Value ranges depend on installed options. For more information, refer to the specifications document.

smFreqOffset float

stream Repeated capability selector

When you do not use any explicit repeated capability selector, the value is taken from its parent group.