from ......Internal.Core import Core
from ......Internal.CommandsGroup import CommandsGroup
# noinspection PyPep8Naming,PyAttributeOutsideInit,SpellCheckingInspection
[docs]class CorrectionCls:
"""Correction commands group definition. 1 total commands, 0 Subgroups, 1 group commands"""
def __init__(self, core: Core, parent):
self._core = core
self._cmd_group = CommandsGroup("correction", core, parent)
[docs] def set(self) -> None:
"""SCPI: [SENSe]:CONFigure:CORRection \n
Snippet: driver.applications.k30NoiseFigure.sense.configure.correction.set() \n
Configures the software to perform calibration measurements. Using method RsFsw.Applications.K10x_Lte.Initiate.Immediate.
set then initiates a calibration instead of the actual measurement, until you deliberately select one of the normal
measurements again with one of the following commands.
INTRO_CMD_HELP: For triggered gated measurements,only the following gate trigger sources are supported: \n
- [SENSe:]CONFigure:FREQuency:CONTinuous
- [SENSe:]CONFigure:FREQuency:SINGle
- [SENSe:]CONFigure:LIST:CONTinuous
- [SENSe:]CONFigure:LIST:SINGle
Note that calibration data is used only when the second stage correction mode has been turned on with
[SENSe:]CORRection[:STATe]. \n
"""
self._core.io.write(f'SENSe:CONFigure:CORRection')
[docs] def set_with_opc(self, opc_timeout_ms: int = -1) -> None:
"""SCPI: [SENSe]:CONFigure:CORRection \n
Snippet: driver.applications.k30NoiseFigure.sense.configure.correction.set_with_opc() \n
Configures the software to perform calibration measurements. Using method RsFsw.Applications.K10x_Lte.Initiate.Immediate.
set then initiates a calibration instead of the actual measurement, until you deliberately select one of the normal
measurements again with one of the following commands.
INTRO_CMD_HELP: For triggered gated measurements,only the following gate trigger sources are supported: \n
- [SENSe:]CONFigure:FREQuency:CONTinuous
- [SENSe:]CONFigure:FREQuency:SINGle
- [SENSe:]CONFigure:LIST:CONTinuous
- [SENSe:]CONFigure:LIST:SINGle
Note that calibration data is used only when the second stage correction mode has been turned on with
[SENSe:]CORRection[:STATe]. \n
Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value. \n
:param opc_timeout_ms: Maximum time to wait in milliseconds, valid only for this call."""
self._core.io.write_with_opc(f'SENSe:CONFigure:CORRection', opc_timeout_ms)