Level

SCPI Command :

[SENSe]:ADJust:LEVel

Commands in total: 1

Subgroups: 0

Direct child commands: 1

set() → None

# [SENSe]:ADJust:LEVel
driver.applications.k9X11Ad.sense.adjust.level.set()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. Thus, the settings of the RF attenuation and the reference level are optimized for the signal level. The FSW is not overloaded and the dynamic range is not limited by an S/N ratio that is too small.

set_with_opc(opc_timeout_ms: int = -1) → None

# [SENSe]:ADJust:LEVel
driver.applications.k9X11Ad.sense.adjust.level.set_with_opc()

Initiates a single (internal) measurement that evaluates and sets the ideal reference level for the current input data and measurement settings. Thus, the settings of the RF attenuation and the reference level are optimized for the signal level. The FSW is not overloaded and the dynamic range is not limited by an S/N ratio that is too small.

Same as set, but waits for the operation to complete before continuing further. Use the RsFsw.utilities.opc_timeout_set() to set the timeout value.

Parameters:

opc_timeout_ms – Maximum time to wait in milliseconds, valid only for this call.